Usa-spec PA15-HON2 Bedienungshandbuch PDF herunterladen (Seite 11)

Note: On some of HONDA radios, the 14-pin connector is located

on the bottom side of the radio chassis.

Section 4. CABLE CONNECTION

in Section 3.

If a factory cable with the same identical 14-pin male connector is already

connected to the radio then unplug the factory cable from the radio first.

on CAS-H2Y cable. Reference Fig. (1).

adaptor where it is labeled RADIO.

with a relay. Reference Fig. (3).

Step 1-Decide which MODE to use and set DIP switches according to information

Step 2-Must remove or eject all CDs from the radio.

Step 3-Remove the radio from dash.

Step 4-Plug the 14-pin male connector on the USA_SPEC CAS-H2y cable to the radio.

Step 6-Plug the factory 14-pin male connector to USA_SPEC 14-pin female connector

Step 7-Plug the round 8-pin DIN connector on the USA_SPEC CAS-H2y cable to the

Step 8-If the vehicle has Rear-Seat-Entertainment system, wire ACCessory power

is selected by DIP switch #1=ON.

Step 9- Connect your audio source to the RCA jacks on the adaptor if AUX option

Step 14- Plug the orange color wire on CAS-HXM to PA15-HON2 adaptor where

Step 15- Go to Step 7, 8, 9, 10 and 11.

it is labeled XM.

14-pin female connector on the USA_SPEC CAS-H2y cable.

Step 13- Plug the 14-pin male connector on the USA_SPEC CAS-HXM cable to the

CAS-HXM cable. Reference Fig. (2) .

Step 12- Plug the factory 14-pin cable to the 14-pin female connector on the USA_SPEC

Step 11- Reinstall radio back to the dash only after a successful test is done.

Step 10- Plug the CB-PA105 cable to the adaptor where it is labeled iPod.

Step 5-If DIP switch #2 is set to OFF position and the vehicle has a factory XM

receiver, skip to step 12.

1 2 ... 6 7 8 9 10 11 12 13 14

Keine Kommentare

Usa-spec PA15-HON2 Bedienungshandbuch Seite 11